پیوندهای مفید
آمار
| تعداد نشریات | 9 |
| تعداد شمارهها | 448 |
| تعداد مقالات | 5,737 |
| تعداد مشاهده مقاله | 8,059,845 |
| تعداد دریافت فایل اصل مقاله | 6,559,927 |
Experimental investigation of fin heat transfer characteristics in different condition | ||
| AUT Journal of Mechanical Engineering | ||
| مقاله 5، دوره 8، شماره 2، 2024، صفحه 151-180 اصل مقاله (4.12 M) | ||
| نوع مقاله: Research Article | ||
| شناسه دیجیتال (DOI): 10.22060/ajme.2024.23065.6096 | ||
| نویسندگان | ||
| Mohammad pourjafargholi* ؛ Alireza Gholami؛ Mohammadreza karimi | ||
| Department of Mechanical Engineering, Khatam al-Anbia Air Defense University, Tehran, Iran | ||
| چکیده | ||
| Applying heat sinks as extended surfaces plays a significant role in cooling various industrial equipment. This study investigates the impact of heat transfer parameters of fins, such as practical geometry, wall heat flux, coolant velocity, and the angle at which the coolant flow interacts with the fin. The geometry of the fins includes rectangular and triangular shapes, with a heat flux range of approximately 4.6-18.5 kW/m2, coolant velocities ranging from 1-2 m/s, and angles of 0º, 45º, and 90º between the fin position and cooling flow direction. Aluminum, known for its high conductivity, was chosen as the material for the fin structure, with air serving as the primary cooling flow. The study found that triangular fins exhibited a higher convective heat transfer rate than rectangular fins, approximately 47.4% higher on average across all conditions. However, rectangular fins dissipated heat from the wall more effectively. Pressure drop was assessed by comparing cooling flow velocities associated with each fin in various positions. Results revealed that the sharp tip of triangular fins reduced the vorticity effect, increased average flow velocity, and decreased pressure drop. Additionally, rectangular fins were approximately 10.4% more efficient on average than triangular fins. The study also concluded that the impact angle had a negligible effect on the efficiency of both rectangular and triangular fins. | ||
| کلیدواژهها | ||
| Fin؛ Heat Transfer Coefficient؛ Pressure Drop؛ Temperature Distribution | ||
| مراجع | ||
|
[1] S.S. Chandrakant, S. Sunilkumar, N. Gokhale, Numerical and experimental analysis of heat transfer through various types of fin profiles by forced convection, International Journal of Engineering Research & Technology (IJERT), 2(7) (2013) 2278-0181.
[2] B. Freegah, A.A. Hussain, A.H. Falih, H. Towsyfyan, CFD analysis of heat transfer enhancement in plate-fin heat sinks with fillet profile: Investigation of new designs, Thermal Science and Engineering Progress, 17 (2020) 100458.
[3] S. Zaidshah, V. Yadav, Heat transfer from different types of fins with notches with varying materials to enhance rate of heat transfer a Review, international journal of applied engineering research, 14(9) (2019) 174-179.
[4] A. Tariq, K. Altaf, S.W. Ahmad, G. Hussain, T. Ratlamwala, Comparative numerical and experimental analysis of thermal and hydraulic performance of improved plate fin heat sinks, Applied Thermal Engineering, 182 (2021) 115949.
[5] P. Prasad, L. Prasad, Cfd analysis on louvered fin, Int Res J Eng Technol, 4(1) (2017) 1458-1462.
[6] A. Hashem-ol-Hosseini, M.A. Ghazani, M.D. Emami, Experimental study and numerical simulation of thermal hydraulic characteristics of a finned oval tube at different fin configurations, International Journal of Thermal Sciences, 151 (2020) 106255.
[7] A. Shadlaghani, M. Tavakoli, M. Farzaneh, M. Salimpour, Optimization of triangular fins with/without longitudinal perforate for thermal performance enhancement, Journal of Mechanical Science and Technology, 30 (2016) 1903-1910.
[8] B. Jalili, N. Aghaee, P. Jalili, D.D. Ganji, Novel usage of the curved rectangular fin on the heat transfer of a double-pipe heat exchanger with a nanofluid, Case Studies in Thermal Engineering, 35 (2022) 102086.
[9] M.A. Ali, S. Kherde, Design Modification and Analysis of Two-Wheeler Cooling Fins-A Review, International Journal of Advances in Engineering & Technology, 7(3) (2014) 998-1002.
[10] I. Satyanarayana, G. Pranay, Design and analysis of rectangular and triangular fins using CFD, International Journal of Scientific Engineering and Technology Research, 5(31) (2016) 6554-6564.
[11] R. Vijayakumar, T. Nithyanandam, A. Janarthanan, N. Jeevanantham, B. Santhosh, Analysis of Rectangular Fins Using CFD, Annals of the Romanian Society for Cell Biology, (2021) 1892-1898.
[12] P.K. Singh, V.K. Sharma, A. Islam, Numerical analysis on thermal properties of aluminium alloy for transforming heat based applications, Materials Today: Proceedings, 45 (2021) 3596-3600.
[13] S. Durgam, A. Kale, N. Kene, A. Khedkar, S. Palve, N.M. Gawai, Thermal analysis of fin materials for engine cylinder heat transfer enhancement, in: IOP Conference Series: Materials Science and Engineering, IOP Publishing, 2021, pp. 012071.
[14] S. Mirapalli, P. Kishore, Heat transfer analysis on a triangular fin, Int J Eng Trends Technol, 19(5) (2015).
[15] M. Torabi, A. Aziz, K. Zhang, A comparative study of longitudinal fins of rectangular, trapezoidal and concave parabolic profiles with multiple nonlinearities, Energy, 51 (2013) 243-256.
[16] R. Karvinen, T. Karvinen, Optimum geometry of plate fins, Journal of heat transfer, 134(8) (2012).
[17] T.L. Bergman, A.S. Lavine, F.P. Incropera, D.P. DeWitt, Introduction to heat transfer, John Wiley & Sons, 2011.
[18] C.-H. Huang, P.-W. Tung, Numerical and experimental studies on an optimum Fin design problem to determine the deformed wavy-shaped heat sinks, International Journal of Thermal Sciences, 151 (2020) 106282.
[19] E. Buckingham, On physically similar systems; illustrations of the use of dimensional equations, Physical review, 4(4) (1914) 345.
[20] M. Pourjafargholi, A. R. Gholami, and M. R. Karimi, "Investigating fin heat transfer in rectangular, triangular and parabolic geometries in singular and groups under laminar and turbulent cooling airflow," Journal of Aerospace Defense, vol. 2, no. 2, pp. 55-83, (2023).
[21] J.G. Collier, J.R. Thome, Convective boiling and condensation, Clarendon Press, 1994.
[22] R.J. Moffat, Describing the uncertainties in experimental results, Experimental thermal and fluid science, 1(1) (1988) 3-17. | ||
|
آمار تعداد مشاهده مقاله: 549 تعداد دریافت فایل اصل مقاله: 389 |
||