پیوندهای مفید
آمار
| تعداد نشریات | 7 |
| تعداد شماره‌ها | 404 |
| تعداد مقالات | 5,423 |
| تعداد مشاهده مقاله | 5,529,999 |
| تعداد دریافت فایل اصل مقاله | 5,024,466 |
Design of two layer clamped-clamped microsensor based on classical and non-classical theories | ||
| AUT Journal of Mechanical Engineering | ||
| دوره 9، شماره 1، فروردین 2025، صفحه 19-32 اصل مقاله (1.27 M) | ||
| نوع مقاله: Research Article | ||
| شناسه دیجیتال (DOI): 10.22060/ajme.2024.23062.6116 | ||
| نویسندگان | ||
| Mohammadreza Davoodi Yekta؛ Abbas Rahi* | ||
| Faculty of Mechanical and Energy Engineering, Shahid Beheshti University, Tehran, Iran, | ||
| چکیده | ||
| In this paper, the two-layer micro sensor is modeled as a two-layer clamped-clamped microbeam and it is optimized by using the genetic algorithm. Using the results of this research, clamped-clamped microbeams can be designed in such a way that the performance of microsensors whose structure includes these microbeams will be improved. The quality factor, the sensitivity, and the maximum stress are selected as objective functions. The sensitivity and the quality factor are the functions of the natural frequency. The natural frequency is calculated based on Rayleigh’s method. The quality factor is calculated by approximation established on the one layer’s quality factor formula. To calculate the maximum stress, the system is assumed as a mass-spring system that has a harmonic displacement and the maximum deflection is the static deflection. The thickness of each layer, the width of the microbeam, and the length of the microbeam are selected as design variables. The optimization is done based on classical and non-classical theory by the genetic algorithm. The results based on both theories are approximately equal. The length of the microbeam is the most important variable and very changes (approximately 190%). The thickness of the silicon layer has the least effect on the results and changes just lower than (approximately 20%). The results show that when the maximum stress decreases and the sensitivity increases, the quality factor decreases which is undesirable. Maximum sensitivity is obtained when the microbeam is very small. | ||
| کلیدواژه‌ها | ||
| Microsensor؛ Clamped-Clamped Microbeam؛ Optimization؛ Sensitivity؛ Quality Factor | ||
| مراجع | ||
|
[1] F. Narita, Z. Wang, H. Kurita, Z. Li, Y. Shi, Y. Jia, C. Soutis, A review of piezoelectric and magnetostrictive biosensor materials for detection of COVID‐19 and other viruses, Advanced Materials, 33(1) (2021) 2005448.
[2] R. Lifshitz, M.L. Roukes, Thermoelastic damping in micro-and nanomechanical systems, Physical review B, 61(8) (2000) 5600.
[3] J. Dennis, A. Ahmed, M.M. Khir, A. Rabih, Modelling and Simulation of the Effect of Air Damping on the Frequency and Quality factor of a CMOS-MEMS Resonator, Appl. Math. Infor. Sci.(AMIS), 9 (2015) 729-737.
[4] W. Pan, H. Li, M. Wang, L. Wang, Elastothermodynamic damping modeling of three-layer Kirchhoff–Love microplate considering three-dimensional heat conduction, Applied Mathematical Modelling, 89 (2021) 1912-1931.
[5] R.D. Mindlin, H. Tiersten, Effects of couple-stresses in linear elasticity, Archive for Rational Mechanics and analysis, 11(1) (1962) 415-448.
[6] F. Yang, A. Chong, D.C.C. Lam, P. Tong, Couple stress based strain gradient theory for elasticity, International journal of solids and structures, 39(10) (2002) 2731-2743.
[7] G. Yun, K. Hwang, Y. Huang, P. Wu, A reformulation of mechanism-based strain gradient plasticity, Philosophical Magazine, 85(33-35) (2005) 4011-4029.
[8] D.C. Lam, F. Yang, A. Chong, J. Wang, P. Tong, Experiments and theory in strain gradient elasticity, Journal of the Mechanics and Physics of Solids, 51(8) (2003) 1477-1508.
[9] M.E. Gurtin, A.I. Murdoch, Surface stress in solids, International journal of Solids and Structures, 14(6) (1978) 431-440.
[10] C. Lim, G. Zhang, J. Reddy, A higher-order nonlocal elasticity and strain gradient theory and its applications in wave propagation, Journal of the Mechanics and Physics of Solids, 78 (2015) 298-313.
[11] R.D. Mindlin, N. Eshel, On first strain-gradient theories in linear elasticity, International Journal of Solids and Structures, 4(1) (1968) 109-124.
[12] S. Kong, S. Zhou, Z. Nie, K. Wang, The size-dependent natural frequency of Bernoulli–Euler micro-beams, International Journal of Engineering Science, 46(5) (2008) 427-437.
[13] S. Park, X. Gao, Bernoulli–Euler beam model based on a modified couple stress theory, Journal of Micromechanics and Microengineering, 16(11) (2006) 2355.
[14] H. Ma, X.-L. Gao, J. Reddy, A microstructure-dependent Timoshenko beam model based on a modified couple stress theory, Journal of the Mechanics and Physics of Solids, 56(12) (2008) 3379-3391.
[15] A. Rahi, Vibration analysis of multiple-layer microbeams based on the modified couple stress theory: analytical approach, Archive of Applied Mechanics, 91(1) (2021) 23-32.
[16] E. Loghman, F. Bakhtiari-Nejad, A. Kamali, M. Abbaszadeh, M. Amabili, Nonlinear vibration of fractional viscoelastic micro-beams, International Journal of Non-Linear Mechanics, 137 (2021) 103811.
[17] S.A. Eftekhari, D. Toghraie, Vibration and dynamic analysis of a cantilever sandwich microbeam integrated with piezoelectric layers based on strain gradient theory and surface effects, Applied Mathematics and Computation, 419 (2022) 126867.
[18] N. Ding, X. Xu, Z. Zheng, E. Li, Size-dependent nonlinear dynamics of a microbeam based on the modified couple stress theory, Acta Mechanica, 228 (2017) 3561-3579.
[19] B. Akgöz, Ö. Civalek, Analysis of micro-sized beams for various boundary conditions based on the strain gradient elasticity theory, Archive of Applied Mechanics, 82 (2012) 423-443.
[20] R. Littrell, K. Grosh, Modeling and characterization of cantilever-based MEMS piezoelectric sensors and actuators, Journal of Microelectromechanical Systems, 21(2) (2012) 406-413.
[21] H. Farokhi, M.H. Ghayesh, Size-dependent parametric dynamics of imperfect microbeams, International Journal of Engineering Science, 99 (2016) 39-55.
[22] R. Ansari, M. Ashrafi, S. Hosseinzadeh, Vibration characteristics of piezoelectric microbeams based on the modified couple stress theory, Shock and Vibration, 2014 (2014).
[23] B. Akgöz, Ö. Civalek, A size-dependent shear deformation beam model based on the strain gradient elasticity theory, International Journal of Engineering Science, 70 (2013) 1-14.
[24] A. Talimian, P. Béda, Dynamic stability of a size-dependent micro-beam, European Journal of Mechanics-A/Solids, 72 (2018) 245-251.
[25] B. Zhao, T. Liu, J. Chen, X. Peng, Z. Song, A new Bernoulli–Euler beam model based on modified gradient elasticity, Archive of Applied Mechanics, 89(2) (2019) 277-289.
[26] S. Yin, Y. Deng, T. Yu, S. Gu, G. Zhang, Isogeometric analysis for non-classical Bernoulli-Euler beam model incorporating microstructure and surface energy effects, Applied Mathematical Modelling, 89 (2021) 470-485.
[27] I. Esen, Dynamics of size-dependant Timoshenko micro beams subjected to moving loads, International Journal of Mechanical Sciences, 175 (2020) 105501.
[28] L. Chen, Y. Liu, S. Zhou, B. Wang, The reformulated micro-beam models by incorporating the general strain gradient elasticity theory (GSGET), Applied Mathematical Modelling, 90 (2021) 448-465.
[29] J. Reddy, Microstructure-dependent couple stress theories of functionally graded beams, Journal of the Mechanics and Physics of Solids, 59(11) (2011) 2382-2399.
[30] M. Kahrobaiyan, M. Rahaeifard, S. Tajalli, M. Ahmadian, A strain gradient functionally graded Euler–Bernoulli beam formulation, International Journal of Engineering Science, 52 (2012) 65-76.
[31] M.H. Ghayesh, Dynamics of functionally graded viscoelastic microbeams, International Journal of Engineering Science, 124 (2018) 115-131.
[32] J. Kim, K.K. Żur, J.N. Reddy, Bending, free vibration, and buckling of modified couples stress-based functionally graded porous micro-plates, Composite Structures, 209 (2019) 879-888.
[33] M. Kumar, B. Mukherjee, S. Sen, Analysis of static charge induced pull-in of an electrostatic MEMS, Communications in Nonlinear Science and Numerical Simulation, 96 (2021) 105690.
[34] S. Veena, A. Sthuti, H. Suresh, M. Nagaraj, Simulation and analysis of suspension based single axis mems capacitive accelerometer, International Journal of Basic and Applied Science, 11(3) (2022) 107-116.
[35] K.S. Pakhare, P. Punith, P. Guruprasad, R.P. Shimpi, On Effects of Shear Deformation on the Static Pull-in Instability Behaviour of Narrow Rectangular Timoshenko Microbeams, in: ASPS Conference Proceedings, 2022, pp. 1817-1822.
[36] S. Valizadeh, M. Fathalilou, G. Rezazadeh, Material dielectricity effects on the performance of capacitive micro-devices: a nonlinear study, International Journal of Mechanics and Materials in Design, 19(3) (2023) 537-552.
[37] A.N.T. Vu, V.N. Pham, D.K. Nguyen, Vibration analysis of functionally graded microbeams with a moving mass based on Timoshenko beam theory, in: IOP Conference Series: Materials Science and Engineering, IOP Publishing, 2023, pp. 012002.
[38] C.I. Le, V.N. Pham, D.K. Nguyen, Size dependent pull-in instability of functionally graded microbeams using a finite element formulation, in: IOP Conference Series: Materials Science and Engineering, IOP Publishing, 2023, pp. 012028.
[39] H. Abo-Bakr, R. Abo-Bakr, S. Mohamed, M. Eltaher, Multi-objective shape optimization for axially functionally graded microbeams, Composite Structures, 258 (2021) 113370.
[40] E. Taati, N. Sina, Multi-objective optimization of functionally graded materials, thickness and aspect ratio in micro-beams embedded in an elastic medium, Structural and Multidisciplinary Optimization, 58 (2018) 265-285.
[41] Y. Fu, L. Li, Y. Hu, Enlarging quality factor in microbeam resonators by topology optimization, Journal of Thermal Stresses, 42(3) (2019) 341-360.
[42] N. Gan, Q. Wang, Topology optimization design related to size effect using the modified couple stress theory, Engineering Optimization, 55(1) (2023) 158-176.
[43] H. Abo-Bakr, R. Abo-Bakr, S. Mohamed, M. Eltaher, Weight optimization of axially functionally graded microbeams under buckling and vibration behaviors, Mechanics based design of structures and machines, 51(1) (2023) 213-234.
[44] C.J. Glassbrenner, G.A. Slack, Thermal conductivity of silicon and germanium from 3 K to the melting point, Physical review, 134(4A) (1964) A1058.
[45] R. Hull, Inspec, Properties of crystalline silicon, INSPEC, the Institution of Electrical Engineers, London, 1999.
[46] A.A. Tatarinova, A.S. Doroshkevich, O.Y. Ivanshina, O.S. Pestov, M. Balasoiu, P.P. Gladyshev, Development of Siloxane Coating with Oxide Fillers for Kesteritic (CZTS) Photovoltaic Systems, Energies, 14(8) (2021) 2142. | ||
|
آمار تعداد مشاهده مقاله: 92 تعداد دریافت فایل اصل مقاله: 73 |
||